Albuquerque drivers may know that most automotive failures in Albuquerque, New Mexico are tire related, but do you know the second most common cause for vehicle failure? Nope, it’s not teenagers. It is the coolant system. But, if you take good care of your sedan coolant system, it will take good care of you.
A sedan’s engine creates a lot of heat – so much heat, that if it is not properly cooled, the engine can lock up, resulting in massive damage and costly repair bills. But when everything is working right, your sedan engine operates at the proper temperature and all is well. Without antifreeze in your cooling system, the water could freeze and cause sedan engine damage. This could be very pricey, not to mention inconvenient.
The right mix of water and antifreeze is critical and protects the engine against damage from freezing and overheating. Antifreeze also protects the coolant system against corrosion that could cause the system to fail. The thing to remember is this: coolant system failure is very common, but it is also very uncomplicated to prevent. Your Albuquerque service center knows the vehicle manufacturer’s recommendations, and can tell you when the coolant needs to be changed. At Jim’s Automotive in Albuquerque, we can perform a coolant system service.
Even the best antifreeze cannot completely protect the coolant system from harmful deposits forever. The anti-corrosion additives are used up over time, so the coolant must be replaced. A coolant service cleans out the system and replaces the old fluid with fresh coolant. A coolant system service at Jim’s Automotive is a low-cost way to protect against major engine repairs down the road. Prevention is the key for Albuquerque car owners. Be sure to watch out for the two main warning signs: if your temperature gauge is in the “hot” zone or if you get a message warning you to check your coolant. If you take a look under the hood, you will see the coolant overflow bottle. You can see there are lines that indicate the proper level of coolant … if your engine is cold – or if it is hot.
Albuquerque auto owners can add water or antifreeze to that bottle themselves, but should be careful. First, you never want to open the radiator pressure cap. The steam could severely burn you. Second, try to get to Jim’s Automotive in Albuquerque immediately if your coolant is low. If that is not possible, follow the directions in your owner’s manual. Third, remember that you need a proper mixture of water and antifreeze, or you will damage your engine. If you make an emergency addition to your cooling system, follow-up with Jim’s Automotive or your service center where they can make necessary corrections. Fourth, not all cars use the same type of antifreeze.
Albuquerque auto owners will need to check their car maker’s owner’s manual to make sure they use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the car maker’s warranty on your sedan cooling system. If you’re not sure, ask your knowledgeable Jim’s Automotive tech at Jim’s Automotive for guidance.